How to fix E01 F03 error on Whirlpool washers?

To fix the E01 F03 error on Whirlpool washers, you can follow these steps: 1. Check the water supply: Ensure that the water valves are fully open and the water supply is not disrupted. Make sure the water pressure is adequate for the washer to function properly. 2. Inspect the hoses: Look for any kinks, twists, or blockages in the hoses that may be hindering water flow. If you find any issues, straighten the hoses and remove any debris. 3. Clean the inlet screens: The inlet screens at the back of the washer may get clogged with dirt or debris over time. Turn off the water supply and disconnect the hoses. Use a soft brush to gently clean the screens, removing any accumulated build-up. 4. Check the drain hose: Ensure that the drain hose is properly connected and not blocked. If you notice any issues, remove the blockage or reconnect the hose securely. 5. Reset the washer: Unplug the washer from the power outlet for a few minutes. This will reset the control board and may resolve the error. After a few minutes, plug it back in and restart the washer. If these troubleshooting steps do not resolve the E01 F03 error on your Whirlpool washer, it is recommended to consult the instruction manual or contact Whirlpool customer support for further assistance.