How to replace hydraulic seals in Case IH MX230?

To replace hydraulic seals in a Case IH MX230, follow these steps: 1. Prepare the workspace: Park the tractor on a flat surface and engage the parking brake. Make sure to wear appropriate safety gear, such as gloves and goggles. 2. Drain hydraulic fluid: Locate the hydraulic reservoir and drain the fluid into a suitable container. Remove the drain plug or open the drain valve to let the fluid fully drain out. 3. Identify the seal to be replaced: Inspect the hydraulic system and identify the specific seal that needs replacement. Note its location and dimensions for ordering the correct replacement seal. 4. Remove old seal: Carefully remove any components blocking access to the seal. Use an appropriate tool, such as a seal puller or pick, to carefully remove the old seal. Take extra care not to damage other components during this process. 5. Clean the area: Thoroughly clean the area around the seal housing using a lint-free cloth or suitable cleaning agent. Ensure that no dirt or debris gets into the hydraulic system during this step. 6. Install the new seal: Lubricate the new seal with compatible hydraulic fluid. Gently press the seal into its designated housing, taking care to avoid any twisting or distortion. Ensure that the seal is seated properly and evenly. 7. Reassemble and test: Carefully reassemble any components removed earlier to access the seal. Refill the hydraulic reservoir with clean fluid, following the manufacturer's recommendations. Start the tractor and test the hydraulic system for any leaks and proper functioning. Remember to consult the tractor's manual or seek professional assistance if you are unsure about any specific steps or need guidance on seal replacement for your Case IH MX230.