LG Washer Won't Fill with Water IE Code - Troubleshooting Guide

If your LG washer displays the "IE" code and is not filling with water, it can be frustrating and disrupt your laundry routine. However, there are several potential causes for this issue, and in this article, we will explore some troubleshooting steps to help you resolve the problem.

Possible Causes

The "IE" code on your LG washer typically indicates a problem with the water inlet valve or water supply. Here are some potential causes:

• A clogged water inlet valve filter
• A faulty water inlet valve
• Low water pressure
• Issues with the water supply line

Troubleshooting Steps

Before seeking professional assistance or considering replacing parts, try these troubleshooting steps:

1. Check the water supply: Ensure that the water supply to your washing machine is turned on and that water is flowing adequately. If you observe low water pressure or no water at all, there might be an issue with your plumbing or water supply line. Contact a plumber if necessary.
2. Inspect the water inlet valve: The water inlet valve controls the flow of water into the washer. Make sure the valve is not clogged or damaged. You can clean the filter/screen attached to the valve to remove any debris that might be blocking the water flow.
3. Test the water pressure: Inadequate water pressure can prevent the washer from filling properly. You can check the water pressure by using a water pressure gauge on an outside faucet. If the pressure is below 20 psi, contact your water provider to address the issue.
4. Reset the washer: Sometimes resetting the washer can help resolve the issue. Unplug the machine from the power source for a few minutes, then plug it back in. Restart the wash cycle and see if the problem persists.
5. Contact LG support: If the problem continues even after trying the above steps, it is recommended to contact LG customer support or schedule a visit from a qualified technician. They can provide further guidance or arrange for necessary repairs.

Conclusion

A "LG washer won't fill with water IE code" message can be frustrating, but by following the troubleshooting steps mentioned above, you can potentially resolve the issue on your own. Remember to check the water supply, inspect the water inlet valve, test the water pressure, and if needed, reset the washer. If the problem persists, it is advisable to reach out to LG support for further assistance. With proper troubleshooting, you can have your washer up and running smoothly again.