Ford Fusion Oil Change Procedure

Regular oil changes are crucial for maintaining the performance and longevity of your Ford Fusion. Changing the oil at recommended intervals helps to keep the engine clean, prolongs its life, and ensures smooth operation. Here is a step-by-step guide to help you perform an oil change on your Ford Fusion:

1. Gather the Tools and Materials

Before you start, make sure you have the necessary tools and materials, which include:

• Oil filter
• Oil pan
• Ratchet and socket set
• Oil filter wrench
• Funnel
• Shop towels or rags
• New oil of the recommended grade and quantity

2. Prepare the Vehicle

Park your Ford Fusion on a level surface and turn off the engine. Engage the parking brake and place wheel chocks behind the rear wheels to prevent any accidental movement. It is also recommended to wear protective gloves and eyewear during the process.

3. Drain the Old Oil

Position the oil pan beneath the oil drain plug located on the bottom of the engine oil pan. Use a ratchet and socket set to remove the drain plug and allow the old oil to completely drain into the pan. Once drained, replace the drain plug.

4. Replace the Oil Filter

Locate the oil filter – usually found on the side of the engine. Carefully loosen the old filter using an oil filter wrench, turning it counterclockwise. Once loose, remove it by hand. Take a small amount of fresh oil and apply it to the rubber gasket on the new oil filter. Then, screw the new filter onto the housing until it's hand-tight. Do not overtighten.

5. Add New Oil

Position a funnel into the oil filler neck, which is typically located on the top of the engine. Slowly pour the recommended amount and grade of new oil into the engine. Refer to your owner's manual for the specific oil capacity of your Ford Fusion’s engine. Once done, remove the funnel and wipe any spilled oil from the engine compartment.

6. Start the Engine and Check for Leaks

Start the engine and let it idle for a few minutes. Inspect underneath the car for any oil leaks around the oil drain plug and oil filter. If you notice any leaks, turn off the engine and tighten the drain plug or filter as necessary.

7. Dispose of Old Oil Properly

Used motor oil must be properly disposed of at a recycling center or an authorized oil collection facility. Do not pour it down the drain or in the trash.

Performing a regular oil change on your Ford Fusion is an essential task that ensures the optimal performance and longevity of your vehicle. By following these step-by-step instructions and using the correct tools and materials, you can easily carry out this maintenance procedure at home.